Map Problem 04-09-2018

I have 9 regions active, however, it only shows the last 4 as rendered maps (see picture).

Do you have any idea how to fix this?

Hi tazzarkin

Reading this post, I assume that your previous post "Table Regions does not exist 04-08-2018" seems to be solved? If yes, what was the issue? Could you pls post it there so others also can read it? thnx

The attached image is a little too small to be able to read the text in yellow ... this would show, where the image creation issue was caused.

Since a few versions, jOpenSim requires the cURL extension for php to be installed, but obviously must be, otherwise the other 4 region images would also not be there.

Have you already tried to click on the region in backend and then above the button "Refresh Map Now"? (Sometimes even a F5 is needed to refresh browser cache).

Greetz
FoTo50

You are right. It shows a cURL error. But why would the 1st 4 regions show okay?



I just ran a cURL test in my domain root directory and everything looked good.

foto50 wrote: Have you already tried to click on the region in backend and then above the button "Refresh Map Now"? (Sometimes even a F5 is needed to refresh browser cache).

You were right! After I went into the back-end and clicked "Refresh Map Now" (and also went into a few maps and clicked saved), and then finally did an F5.... everything worked!!

All the maps are showing now!!